Niko 10-525 Gebrauchsanleitung Seite 18

10-525
4.2. Indication LEDs
Status
4.3. Volumeregelaar
Use the scroll wheel at the bottom of the internal unit to select from eight different levels and to set the ring and speech volume (independently):
• You adjust the speech volume during a conversation.
• You adjust the ringtone volume if no conversation is active.
5. SETTINGS AND PROGRAMMING
5.1. Programming using the service set
To assign the internal unit to a bell push button as a first or second device, check the manual of the power supply (10-80X) or the service set
(10-870).
To assign the internal unit to a bell push button as a third or fourth device, you will need to parallel connect the device (as a slave) with another
internal unit.
Tip: For easy programming, it is recommended that you stick the serial numbers of all internal and external units that are part of the installation
onto the wiring diagram. The serial numbers can be found on the packaging and on the device. The serial number of this intercom can be found
inside the upper frame.
1. Connect the service set to the installation using terminals a, b and P or using the designated connector on the external unit.
2. Enter the key combination on the service set depending on the type of action you wish to perform.
Action
Find internal unit
15
Programme call forwarding
Programme ring-and-come-in function
Programme internal call
Meaning
The red indication LED will be illuminated if the ring signal is switched off.
The red indication LED will flash in the following cases:
• the call forwarding function is activated.
• the ring-and-come-in function is activated.
• the ring signal is deactivated.
The red indication LED will no longer be illuminated in the following cases:
• the ring signal is activated.
• the call forwarding function is deactivated.
• the ring-and-come-in function is deactivated.
The green indication LED will be illuminated in the following cases:
• call from the external unit;
• during a conversation.
The green indication LED will flash three times when the line is engaged (someone else on the line).
Both indication LEDs will be illuminated when the ringtone selection is activated (see § 5.2.).
Both indication LEDs will flash in case of an error message (see § 6).
Key combination
* 52 #
* 90 # serial number internal unit # serial number internal unit for forwarding #
This function is activated using the free function key (see § 4.1)
* 91 # serial number internal unit #
This function is activated using the free function key (see § 4.1)
* 92 # serial number internal unit # serial number internal unit to be called #
This function is activated using the free function key (see § 4.1)