Operation; Before Switching On For The First Time; Switching On And Off; Transport Lock - Silvercrest SFR 37 A1 Bedienungsanleitung

6. Operation

6.1 Before switching on for
the first time
CAUTION:
after unpacking, there could still be oil
residues on the shaving foils. Remove
these with an absorbent, lint-free cloth
before using the device for the first
time.

6.2 Switching on and off

Irrespective of the battery's charging status,
the device can be used at any time in mains
operation.
1. In order to use the power pack, ensure
that the device is switched off.
2. Connect the plug-in power unit 13 to
the socket 8 on the device.
3. Insert the plug-in power unit 13 in into
an easily accessible wall socket, the
voltage of which corresponds to the
rating plate.
4. Remove the protective lid 10 before
switching on.
5. To switch on the device, push the on/
off switch 6.
6. When switching on ...
... the display is lit blue,
... the charging state is shown,
... the lock symbol briefly appears on
the display 7.
7. To switch off the device, push the on/off
switch 6 again.
8
GB

6.3 Transport lock

If the transport lock is activated, a lock sym-
bol appears on the display 7.
• Press and hold the on/off switch 6 for
approx. 3 seconds, in order to switch
the transport lock on/off.
• Connecting the plug-in power unit 13
deactivates the transport lock, which
cannot be activated during mains op-
eration.

6.4 Shaving

DANGER! Risk of electric
shock!
The hand-held device and the plug-in
power unit are not waterproof and are
therefore not allowed to be used in a
shower/bath.
WARNING!
Do not use the device on open
wounds, cuts, sunburn or blisters.
Do not place excessive pressure on the
shaving foils 1. They are thin and can
be damaged easily.
NOTES:
• The device is suitable for both dry and
wet shaving (Wet & Dry).
• Initial use may cause temporary irritation
or redness of the skin, as the skin has to
adjust to shaving. This is normal and usu-
ally lasts between 2 and 4 weeks.
Dry shaving (Rechargeable bat-
tery and mains operation)
• Hold the device at a right angle to the
skin surface and gently guide it over
your face.
• Shave against the direction of your
beard growth.