Pioneer KRP-600A Bedienungsanleitung Seite 106

15 Additional information
Problem
OTHER
• Power ON indicator or STANDBY
indicator is quickly flashing.
If the following error codes appear on the screen, check the corresponding items in the table.
Code
SD04 and SD11
SD05
SD11
Signal names for 15-pin mini D-sub connecter
Pin No. Signal name
1 R
2 G
3 B
4 Not connected
5 Not connected
6 GND (ground)
7 GND (ground)
8 GND (ground)
106
En
Possible solution
• Internal protective circuits may have been activated. For the display, first turn Power On (a) off,
wait one minute or more, then switch the power on again by turning Power On (a) on. If the
indicator is still flashing, unplug the display's power cord from the power outlet. Wait one to two
minutes then plug in the display again. For the Media Receiver, unplug the Media Receiver's
power cord from the power outlet. Wait one to two minutes then plug in the Media Receiver again.
If this does not solve the problem, contact a Pioneer Service Center. These are listed on your
warranty card for each country. Alternatively, check the Pioneer Web site (see back cover) for
contact details.
Message
Powering off. Internal temperature is too high.
Check temperature around the display.
Internal protection circuits turning power OFF.
Possible short in the speaker cable.
Powering off. Internal temperature is too high.
Check temperature around media receiver.
Check
Check if the ambient temperature of the display is high.
Check the speaker cable connections between the display and
the speakers.
Check if the ambient temperature of the Media Receiver is
high.
Pin No. Signal name
9 +5 V
10 GND (ground)
11 Not connected
12 SDA
13 HD
14 VD
15 SCL