Kärcher SB VC 2 Originalbetriebsanleitung Seite 30

Menue point Important
If the system is operated in CAN master mode (car wash plant),
any settings can only be made on the central control.
To acknowledge the fault, switch off the main switch, remedy the
fault, wait at least 5 seconds and switch the system back on
again.
The total turnover cannot be reset.
Turnover / Turnover vacuum cleaner 1 / Turnover vacuum clean-
er SG 2 / Turnover combined:
The corresponding turnover can be reset.
To do so, press the LEFT and RIGHT button simultaneously and
confirm with the "OK" button.
Cancel using the "ESC" button.
Can only be reset by Service.
The corresponding filter can be reset.
To do so, press the LEFT and RIGHT button simultaneously and
confirm with the "OK" button.
Cancel using the "ESC" button.
– 11
30 EN