Auto Changeover Operation; (Heat Pump Type) - LG MV24AH Bedienungsanleitung

Operating Instructions
Soft dry Operation Mode
Soft dry
Operation
Auto Operation (Cooling type)
Auto
Auto Operation (Heat pump type)
Auto
Auto Changeover Operation (Pair system) :
You can switch the indoor fan speed.
The system will automatically switch from the cooling mode to the heating mode, or from heating to cooling,
when you select Auto Opration mode.
Auto Operation (Multi system or Simultaneous system) :
You can switch the indoor fan speed.
If the system is not operating as desired, manually switch to another mode. The system will not
automatically switch from the cooling mode to the heating mode, or from heating to cooling, then you must
set the mode and the desired temperature again.
10 Convertible & Ceiling suspended Air Conditioner
During Soft dry Operation
If you select the soft dry mode on the OPERATION MODE SELECTION BUTTON,
the product starts to run the soft dry function. It automatically sets the room
temperature and airflow volume to the best condition for dehumidification, based on
the sensed current room temperature.
In this case, however, the setting temperature is not displayed on the remote controller
and you are not able to control the room temperature either.
During the soft dry function, the airflow volume is automatically set according to the
optimization algorithm responding to the current room temperature status, so that the
room condition is kept healthy and comfortable even in the very humid season.
To run the soft dry mode follow steps 1, and 2 and 4
(See operation mode)
In this operation mode the actual setting temperature and the fan speed are
automatically set by the electronic control logic based on the current room
temperature. If you feel hot or cold press the temperature setting buttons
respectively for more cooling or heating effect.
NOTE : You cannot set the actual setting temperature and the indoor fan
speed in this operation mode. But you can use the Chaos swing
in this operation.
If the system is not operating as desired, switch manually to another mode.
To run the auto operation follow steps 1, and 2. (See operation mode)
Auto operation basically is heating or cooling function of the air conditioner.
But during this operation the controller changes the operation mode
automatically to keep the temperature within ±2°C with respect to the
setting temperature.
To run this operation follow steps 1, 2, 3, and 4. (See operation mode)