Commissioning; Frost Protection Function; Fan Heater - Silvercrest SOR 2600 A1 Bedienungsanleitung

Commissioning

1. Unwind all of the power cable from the power
cable retainer 7.
Note:
Ensure that the thermostat 3 and the heat level
switch 2 are standing at MIN resp. 0.
2. Insert the power plug into a wall power socket.
3. Place the heat level switch 2 at "III" and the
thermostat 3 at MAX. The control lamp "Power"
1 glows.
Important:
With the heat level switch 2 you can regulate how
quickly the appliance warms up. If you wish to heat
it up particularly quickly, select heat level "III", if a
slow warming up is preferred, select heat level "I".
Using the thermostat 3 you can set it to the desired
temperature.
4. When the desired room temperature has been
reached, slowly turn the thermostat 3 back until
a quiet "click" is heard and the control lamp
"Power" 1 extinguishes. The momentary room
temperature will now be retained. It could be
that every now and then the control lamp
"Power" 1 switches itself on and then back off.
This means that the programmed room tempera
ture had fallen below this level for a short period
and the appliance had warmed itself back up.
Note:
If you want to heat a room up particularly quickly,
activate additionally the warm air switch 4.
When the warm air switch 4 is positioned at ON,
the warm air control lamp 4 glows and warm air is
blown through the warm air outlet 5 into the room.
5. If you wish to switch the appliance off, first place
the warm air switch 4 at the position OFF. Next,
turn the heat level switch 2 to "0" and then the
thermostat 3 to MIN.
6. Remove the plug from the wall power socket.

Frost protection function

You can adjust the oil filled radiator so that it auto
matically switches on and heats up when the room
temperature reaches about 5°C:
1. Insert the plug into a mains power socket.
2. Position the heat level switch 2 at "I", "II" or
"III", and the thermostat 3 at MIN.
The oil radiator will now switch itself on if the tempe
rature falls to about 5°C. As soon as the room tem
perature rises to above about 5°C, t he oil radiator
switches itself off automatically.

Fan Heater

You can use the oil radiator as a heating fan:
1. Insert the plug into a mains power socket.
2. Place the heating fan switch 4 at ON.
The red heating fan indicator lamp 4 lights up
and warm air will now be blown through the he
ating fan exit 5 into the room.
3. To switch the heating fan off, place the heating
fan switch 4 at OFF.
The red heating fan indicator lamp 4 extinguis
hes.
- 4 -