Before Starting Up - Parkside PDTS 6.3 A1 Bedienungs- Und Sicherheitshinweise

Warnings specific to the pneumatic angle grinder / Operation
Otherwise, accessories turning
faster than permitted may be
damaged irreparably.
Make sure that the parting disc
„ z
size is appropriate for the pneu-
matic angle grinder and that the
parting disc fits on the spindle.
Parting discs must be stored and
„ z
handled with care and in accord-
ance with the manufacturer's
instructions.
Inspect the parting disc before
„ z
use, and discard all that have
spalled, fractured, or sustained
any other damage.
Before use, make sure that the
„ z
parting disc has been fitted cor-
rectly and tightened securely, and
let the device run idle for thirty
seconds in a safe place. Stop the
machine immediately there are
considerable vibrations or defects.
If this is the case, examine the
devices and identify the cause.
Do not use separate adapters or
„ z
adapter bushes: use instead
parting discs with a larger hole
diameter.
Always use the recommended
„ z
guard supplied with the pneumatic
angle grinder. The opening in the
guard must face away from the
operator.
Do not use angle grinders for
„ z
face cutting.
The parting disc continues
„ z
rotating even after the device has
been switched OFF. After switch-
ing OFF, the device may not be
put down until the parting disc
has come to a complete stop. This
precautionary measure serves to
prevent not only serious accidents,
but also dust and chips from being
sucked into the devices.
z Operation
z Before starting up z
Fit the parting disc
Disconnect the compressed air supply from the
compressed air connection.
7
Use the assembly key
place, at the same time loosening the hex screw
and flange with the Allen key
Fit the new parting disc
8
dle. Use the Allen key
screws. Check that the parting disc has been fitted
correctly and can rotate without hindrance!
Compressed air connection
Trigger arm
Switch ON guard
Compressed air supply and connection. Use
filtered, lubricated, and regulated compressed air
only. The following figure illustrates the correct way
to lock the spindle in
8
.
6
and flange on the spin-
to tighten firmly the Allen
Protective cowl
Hex screw
Spindle
Flange
75 mm parting disc
GB/IE/NI 31