Additional Safety Instructions For Pneumatic Machines - Parkside PDTS 6.3 A1 Bedienungs- Und Sicherheitshinweise

The pneumatic angle grinder must
† z
be operated and serviced as
recommended in these instructions
if there is to be no unnecessary
increase to noise levels.
If the pneumatic angle grinder is
† z
fitted with a silencer, always make
sure that this is in place and in full
working order when the machine
is operating.
The consumables / machine tools
† z
must be selected, serviced, and
replaced in compliance with
the recommendations in these
instructions if there is to be no
unnecessary increase to noise
levels.
HAZARDS FROM VIBRATIONS
Vibrations can prove detrimental
† z
to the nerves and blood circula-
tion in hands and arms.
When working in cold environ-
† z
ments, wear warm clothing, and
keep your hands warm and dry.
If you start feeling numbness,
† z
tingling, or pain in your fingers or
hands, or the skin of your fingers
or hands starts turning white, stop
work with the pneumatic angle
grinder, notify your employer, and
seek medical advice.
The pneumatic angle grinder must
† z
be operated and serviced as
recommended in these instructions
Safety instructions for pneumatic tools
if there is to be no unnecessary
increase to vibration levels.
Do not let the machine tool chatter
† z
on the workpiece: this will in all
probability increase the vibrations
to a great extent.
The consumables / machine tools
† z
must be selected, serviced, and
replaced in compliance with the
recommendations in these instruc-
tions if there is to be no unneces-
sary increase to vibration levels.
Whenever possible, use a column,
† z
clamp, or balancing device to
hold the machine's mass.
Keep a reliable, but not too tight
† z
grip on the machine, noting the
force of your manual response:
vibration levels tend to increase
with tighter grips.
Use suitable intermediate wheels
† z
with bonded abrasives.
ADDITIONAL SAFETY
INSTRUCTIONS FOR
PNEUMATIC MACHINES
Compressed air can cause
† z
grievous injury.
When the machine is not in use
† z
and before replacing accessories
or performing repairs, make sure
that the air supply has been shut
off, the air hose is unpressurised,
and the machine has been
disconnected from the air supply.
GB/IE/NI 29