Silvercrest SHAZ 22.2 A1 Bedienungsanleitung Seite 8

__CPE284657_Staubsauger_B7.book Seite 6 Dienstag, 13. Dezember 2016 2:36 14
If the device (base station) has neverthe-
less fallen into water, pull out the power
adapter immediately, and only then
take the device out of the water. Do not
use the device again, and have it
checked by a specialist workshop.
Never touch the device with wet hands.
DANGER! Risk of electric
shock
Lay the power cable such that no one can
step on it, get caught on it, or trip over it.
Only connect the power adapter to a
properly installed and easily accessible
wall socket whose voltage corresponds
to the specifications on the rating plate.
The wall socket must continue to be eas-
ily accessible after the device is
plugged in.
Ensure that the power cable cannot be
damaged by sharp edges or hot points.
Do not wrap the power cable around the
device (Danger! Risk of cable damage!).
Ensure that the power cable cannot be
trapped or crushed.
To pull the power adapter out of the
wall socket, always pull on the power
adapter, and never on the power cable.
Disconnect the power adapter from the
wall socket...
... if there is a fault,
... as long as you do not charge the bat-
tery,
... prior to cleaning the base station,
and
... during thunderstorms.
If the power cable or the device (base
station) is damaged, immediately pull
the power adapter out of the wall sock-
et.
DANGER - danger of
explosion
Never throw the battery into open fire.
6
GB
WARNING! Risk of material damage
Fasten the base station firmly to the
wall. Check whether the enclosed fixing
material is suitable. If necessary, use
other screws and rawlplugs. If in doubt,
have the assembly performed by an ex-
pert.
Before drilling, check that there are no
water pipes or power cables in the wall
at the relevant point.
Only use the rechargeable vacuum
cleaner with all filters installed. Vacuum-
ing without the filters installed destroys
the motor.
Never come close to hair or loose cloth-
ing with the rotating brush.
Use the original accessories only.
Do not use any astringent or abrasive
cleaning agents.
NOTES on the battery
• Only use the original battery charger
(base station) to load the batteries.
• The battery becomes warm during the
charging process. This is normal.