Intended Use; Items Supplied; Technical Data - Hilti HDE 500-A22 Original Bedienungsanleitung

Rear locating lug for installation of the foil
=
pack holder
Parallel piston rods with grip
%
Release button
&
Grip
(
Trigger
)
Dispensing mode selector switch
+
Battery
§
Battery release buttons (also used to
/
activate the charge status indicator)

3.2 Intended use

The tool is designed to dispense the contents of Hilti foil packs in a controlled operation. The HDE 500­A22
cordless dispenser is designed exclusively for use with Hilti 330 ml or 500 ml foil packs.
Depending on the type of foil pack, the tool can be used with either a black or a red foil pack holder:
Black foil pack holder: Used to dispense Hilti mortars supplied in black or white foil packs.
Red foil pack holder: Used to dispense Hilti mortars supplied in red foil packs.
▶ Use only Hilti Li-ion batteries of the B22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series for these batteries.

3.3 Items supplied

Tool and operating instructions
Note
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Center or online at: www.hilti.com

4 Technical data

4.1 Technical data
Weight
Rated voltage
4.2 Noise information and vibration values determined in accordance with EN 60745-1
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure. The data given represents the main applications of the power tool.
However, if the power tool is used for different applications, with different accessory tools, or is poorly
maintained, the data can vary. This can significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the
total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: maintaining the power tool and accessory tools, keeping the hands warm,
organization of work patterns.
Typical A-weighted sound power level (L
Uncertainty for measured sound power level (L
Typical A-weighted emission sound pressure level (K
Uncertainty for the sound pressure level (K
12 English
Printed: 13.12.2016 | Doc-Nr: PUB / 5069934 / 000 / 06
HDE 500-A22
2.62 kg
21.6 V
HDE 500-A22
) 78 dB
WA
) 3 dB
pA
) 67 dB
WA
) 3 dB
pA