•
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep away the
cable from operating range and do not dunk it into water.
•
Do not move or tilt the device when in operation.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with that of the
device (see type label).
Connect the device only in case of compliance! Take note of the security advice!
5.2 Installation and connection
•
Discard the complete packing material after unpacking the device.
•
Remove the lid and take out the filter basket along with the submersion tube from the water
reservoir.
•
Prior to first use, clean the filter basket, lid and inside of reservoir with water and a mild
cleaning agent. Rinse thoroughly in clean water to remove any chemicals.
CAUTION!
Do not dunk the bottom of the device into water!
•
Clean the submersion tube using a brush for bottles, warm water and a mild cleaning agent.
Rinse thoroughly in clean water.
•
Insert the standpipe in the hole of the filter basket when assembling.
•
Place the device on top of an even and safe surface which supports the weight of the device
and is not heat sensitive.
•
Not at any time should you place the device on an inflammable surface (such as: table cloth,
carpet, etc.).
•
You must not position the device near open fireplaces, electric ovens/arc furnaces, furnaces/
electric heaters or other heat sources.
•
Position the device in a way so that the power plug is always accessible.
5.3 Operating
Brewing coffee
•
Fill the reservoir with cold water (check the level indicator to see how much)
•
Make sure to use the minimum amount of coffee for brewing, which is:
for device A190.141 → 20 cups → approx. 3 liters
for device A190.161 → 20 cups → approx. 3 liters
for device A190.191 → 40 cups → approx. 6 liters
CAUTION!
Do not fill the coffee maker at levels higher than those indicated!
Never use warm water for brewing coffee!
- 22 -