Resetting To The Factory Default Settings; Further Information - Axis Q6032-E Installationsanleitung

Page 14

Resetting to the Factory Default Settings

This will reset all parameters, including the IP address, to the Factory Default settings:
1. Remove the dome cover from the camera unit, this will automatically disconnect power from
the camera.
2. Press and hold the Control button and the Power button, see illustration on page 4.
3. Keep the both buttons pressed until the Status indicator LED flashes amber (this may take up to
15 seconds).
4. Release the Control button. When the Status indicator LED displays green (which can take up to
1 minute) the process is complete and the camera has been reset.
Note:
The Status indicator LED will display green for 10 seconds only. After that it will be unlit.
Refer to the Status LED table on page 6 for more information.
5. Release the Power button and replace the dome cover, this will automatically reconnect power
to the camera.
6. Re-assign the IP address, using one of the methods described in this document.
It is also possible to reset parameters to the original factory default settings via the web interface.
For more information, please see the online help or the user's manual.
Accessing the camera from the Internet
Once installed, your AXIS Q6032-E is accessible on your local network (LAN). To access the camera
from the Internet, network routers must be configured to allow incoming traffic, which is usually
done on a specific port.
• HTTP port (default port 80) for viewing and configuration
• RTSP port (default port 554) for viewing H.264 video streams
Please refer to the documentation for your router for further instructions. For more information on
this and other topics, visit the Axis Support Web at www.axis.com/techsup

Further information

The user's manual is available from the Axis Web site at www.axis.com or from the Axis Network
Video Product CD supplied with this product.
Tip!
Visit www.axis.com/techsup to check if there is updated firmware available for your
AXIS Q6032-E. To see the currently installed firmware version, see Setup > About.
AXIS Q6032-E Installation Guide