Tips For The Milk Froth; Generating Hot Water - Silvercrest SEM 1100 A2 Bedienungsanleitung

GB

Tips for the milk froth

Generating hot water

14
NOTICE
► You can also use the milk frother
or tea.
NOTICE
► Absolutely clean the milk frother
"Cleaning and Care".
■ In principle, any type of milk can be frothed, including soy and rice milk.
However, some types of milk can only be frothed with limitations.
■ Skimmed or low-fat milk does not burn as easily as whole milk, but with a too
low fat content there is a risk that the milk froth will not be good. Therefore, if
possible use a milk with 3.5% or 1.5% fat content.
■ Well chilled milk can be frothed better than less cold.
■ Do not froth milk up a second time, otherwise it could burn on.
■ Allow frothed milk to stand for about 30 seconds before you pour it onto the
espresso. Thus, larger bubbles burst and still fl uid milk falls to the bottom. You
can then pour the fi ne froth onto the espresso.
1) When the appliance is heated-up:
2) Place a cup under the milk frother
3) When the green heating-up control lamp
knob 2 to the position "+".
4) Turn the rotary switch
zle.
5) If you wish to interrupt the hot water supply, turn the steam control knob
off (as far as it will go in the direction "-") and place the rotary switch 5 at
the position " ".
6) Switch the appliance off with the on/off switch
NOTICE
► After 3 minutes the appliance will switch itself off automatically.
z to heat up other liquids, such as cocoa
z after every use. Refer to the chapter
z.
4 glows, turn the steam control
5 to the position "
". Hot water fl ows from the noz-
3.
SEM 1100 A2
2