Led Display; Supported Devices - Siemens SCALANCE WLC711 Kompaktbetriebsanleitung

3.3

LED display

Status displays
The L2 and L3 LEDs each flash at 1 second intervals.
If the L2 and L3 LEDs flash yellow together at an interval of 2 seconds, an upgrade or the import of a configuration following
an upgrade is being performed.
3.4

Supported devices

The following devices are supported by the SCALANCE WLC711:
● SCALANCE W788C-2 RJ-45
● SCALANCE W788C-2 M12
● SCALANCE W788C-2 M12 EEC
● SCALANCE W786C-2 RJ-45
● SCALANCE W786C-2IA RJ-45
● SCALANCE W786C-2 SFP
● SCALANCE W786-2HPW
● Extreme Networks AP3610
● Extreme Networks AP3620
● Other devices (non-Siemens) in 3rd-party mode
For these devices, addresses authorizations and filter settings must be entered individually. You will find more detailed
information in the SCALANCE WLC711 User Guide in the section "Working with Third-party APs".
4 Mounting
4.1 Permitted mounting positions
Note
The device is approved for operation in closed rooms only.
Ensure that there is a minimum clearance to the other components or the walls of a housing:
Below at least 100 mm
•
Above at least 50 mm
•
Note
Expansions or additional components
Expansions or additional components are not permitted for this device.
18
LED Meaning
PWR Power supply
L1 -
L2 Battery display
L3 RUN/STOP
LED Description
OFF Standby mode
GREEN Supply voltage is applied.
- -
flashing RED Battery low (remaining life less than 1 month).
Battery empty.
RED
Flashing System is starting up.
YELLOW
System running.
flashing GREEN
SCALANCE WLC711
A5E03740572-05, 04/2016