Korg KAOSS PAD KP3+ Bedienungsanleitung Seite 19

Connecting the USB connector
If you connect the KP3+'s USB connector di-
rectly to your computer, you'll be able to use
your computer to manage the data on the card
that's in the KP3+'s card slot.
Follow the procedure for the operating system
on your computer.
Windows users
TIP Before you continue, power-on your computer
and start up the operating system.
1. Use a USB cable to connect the KP3+ to
your computer.
Plug in the connector of the USB cable that
is connected to your computer into the KP3+'s
USB connector.
Make sure that the connector is oriented cor-
rectly, and insert it as far as it will go.
TIP: When you connect the KP3+ for the first time,
the standard Windows device driver will be installed
automatically.
2. The drive name of the card in the card slot
will appear on your computer.
3. Hold down the SHIFT button and press the
PROGRAM MEMORY 7 (USB) button. The
display will indicate "rdy."
TIP The contents of the KP3+'s card won't be vis-
ible from your computer until you enter "USB Storage
Mode."
From this point until you've completed step 5, you
must not disconnect the USB cable, remove the card from
the slot, or switch the power of your computer on or off.
Doing so may damage the data.
4. To view the contents of the KP3+'s card,
open the drive that was added to your com-
puter in step 2.
Copy the desired data onto your computer.
You can also copy data from your computer
onto the card.
5. Exit USB mode.
In Explorer or My Computer, right-click the
"Removable Disk" icon and choose "Remove."
Then press the KP3+'s SHIFT button to exit
USB mode.
When you're ready to disconnect the KP3+ from your
computer, you must first exit USB mode and then discon-
nect the USB cable.
MacOSX users (OSX 10.5 or later)
1. Use a USB cable to connect the KP3+ to
your computer.
Plug the USB connector into the KP3+'s USB
connector. Make sure that the connector is ori-
ented correctly, and insert it as far as it will go.
2. Hold down the SHIFT button and press the
PROGRAM MEMORY 7 (USB) button.
The display will indicate "buSy."
3. The drive name of the card in the card slot
will appear on your computer.
While this screen is shown, you must not disconnect
the USB cable, remove the card from the slot, or switch the
power of your computer on or off. Doing so may damage
the data.
4. To view the contents of the KP3+'s card,
open the drive that was added to your com-
puter in step 2.
Copy the desired data onto your computer.
You can also copy data from your computer
onto the card.
5. When you're ready to disconnect the KP3+,
drag the drive from the desktop into the Trash.
Then press the KP3+'s SHIFT button to exit
USB mode.
When you're ready to disconnect the KP3+ from your
computer, you must first exit USB mode and then discon-
nect the USB cable.
19