Specifications; Double Insulation - Makita UH5580 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch trigger B
1-2. Switch trigger A
1-3. Switch trigger C
5-1. Hook complete
5-2. Tool's cord
5-3. Extension cord
6-1. Holder
6-2. Cord
7-1. Holder
7-2. Arm cord hook
11-1. Trimming direction
11-2. Tilt the blades
11-3. Hedge surface to be trimmed

SPECIFICATIONS

Strokes per minute (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbol
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･

DOUBLE INSULATION

･
Do not expose to rain.
･
Remove
immediately if the cable is damaged or
cut.
･
Only for EU countries
Do not dispose of electric equipment
together
material!
In observance of European Directive
2012/19/EU on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Explanation of general view
16-1. Press
16-2. Chip receiver
16-3. Nut
16-4. Shear blade
17-1. Nut
17-2. Branch catcher
18-1. Hooks
18-2. Fit the hooks into groove
18-3. Grooves
19-1. Press the levers on both sides
19-2. Unlock the hooks
20-1. Screws
20-2. Blade cover
Model
Blade length
-1
)
Overall length
Net weight
Safety class
plug from the
with household
equipment and
environmentally compatible
UH5580
550 mm
1,500
970 mm
4.3 kg
END220-5
Intended use
The tool is intended for trimming hedges.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
mains
The typical
according to EN60745:
Sound pressure level (L
Sound power level (L
waste
Uncertainty (K) : 0.7 dB(A)
its
Vibration
The vibration
determined according to EN60745:
Work mode : hedge trimming
Vibration emission (a
Uncertainty (K) : 1.5 m/s
5
21-1. Under cover
21-2. Blade cover
22-1. Gear housing cover
23-1. Crank
24-1. Screws
24-2. Shear blade
25-1. Crank
26-1. Ellipse of shear blade
28-1. Ellipse of shear blade
28-2. Crank
29-1. Crank
UH6580
650 mm
1,500
1,049 mm
4.4 kg
/II
A-weighted noise level
) : 86.5 dB(A)
pA
) : 94.5 dB(A)
WA
Wear ear protection
total value (tri-axial
2
) : 4.4 m/s
h
2
UH7580
750 mm
1,500
1,157 mm
4.6 kg
ENE014-1
ENF002-2
ENG905-1
determined
ENG900-1
vector sum)