Ordering Accessories; Open-Source-Software - Philips FC8932 Bedienungsanleitung

English
22

Ordering accessories

Open source software
Replacement
Replacing the filter
Replacing the side brushes
To buy accessories or spare parts, visit www.shop.philips.com/service or go
to your Philips dealer. You can also contact the Philips Consumer Care
Center in your country (see the international warranty leaflet for contact
details).
Your robot runs on open source software. Philips offers to make available
upon request a complete machine-readable copy of the source code on a
medium customarily used for software exchange at a charge not higher
than the cost of physically transferring a copy.
This offer is valid for a period of 3 years after the date of purchase of this
product. To obtain a copy of the source code, please write to:
Open Source Team, Philips Intellectual Property and Standards
P.O. Box 220, 5600 AE Eindhoven, Netherlands
Email address: open.source@philips.com
Replace the filter if it is very dirty or damaged. You can order a new filter kit
under type number FC8066. See 'Emptying and cleaning the dust
container' in chapter 'Cleaning and maintenance' for instructions on how to
remove the filter from the dust container and how to place it in the dust
container.
Replace the side brushes after some time to ensure proper cleaning results.
Always replace the side brushes when you notice signs of wear or damage.
We also recommend that you replace both side brushes at the same time.
You can order spare side brushes as part of replacement kit FC8068. This
kit also contains two filters and three dry wipes.
1 To replace the side brushes, grab the old side brushes by the bristles and
pull them off their shafts.