Intended Use; Programming The Remote Control - Centronic TC511 Bedienungsanleitung

Operating Instructions
The TC511 may only be used for controlling roller shutter and venetian blind
systems.
Connection of other devices must be carried out in consultation with specialised
dealers.
Note
Ensure that the control is not installed and operated near metal sur-
faces or magnetic fi elds.
Radio sets transmitting at the same frequency can lead to interference
with the reception.
It is to be noted that the range of the radio signal is restricted by legisla-
tors and planning regulations.

Programming the remote control

1) Learning the master transmitter
a) Put receiver into learn mode
Note
Please refer to the operating instructions for the receiver.
• Switch off the receiver's power supply and reconnect after 5 seconds.
or
• Activate the "Learn" key or the radio-controlled receiver switch.
The receiver will then be in "Learn" mode for 3 minutes.
b) Learn master transmitter
When the receiver is in "Learn" mode, the learn button is to be pressed until the
receiver indicates that the learn process has been successfully completed.
The learn process is now complete.
36

Intended use