Mounting An Aligning The Pulley For Travel Power - Dometic Travel Power 3.5 Montageanleitung

Installing Travel Power
Key to fig. a, page 7:
No.
1
2
A
B
10.1.2

Mounting an aligning the pulley for Travel Power 3.5/5.0

To obtain as good alignment as possible between the drive pulley and the
generator pulley it may be necessary to put washers on the generator
shaft behind the pulley
Key to fig. 0, page 7:
No.
1
2
3
4
5
6
➤ The washers for alignment have to be placed on the large support
washer (fig. 0 1, page 7).
➤ Remaining washers for alignment should be placed between pulley
(fig. 0 3, page 7) and nut (fig. 0 2, page 7). Relative position
between washers is unimportant.
26
Description
No contact between pulley and large support washer means no
force transmission between shaft and bearing
Washer to make possible alignment and contact between pulley
and large support washer
Pulley thread
Rest space ≥14.1 + 0.5 mm
Description
Large support washer
(part of the generator)
Nut
(torque: 80 ± 5 Nm/8 ± 0.5 kpm/59 ± 3.7 ft lb)
Pulley
Position ring
Fixing plate
Bearing
Dometic Travel Power
EN