Standard Accessories; Battery Removal/Installation - Hitachi WF 4DY Bedienungsanleitung

STANDARD ACCESSORIES

(1) Screw feed attachment .......................................... 1
(Assembled in main body)
(2) No. 2 Plus Bit .......................................................... 1
(Assembled in main body)
(3) Hook ........................................................................... 1
(4) Charger (UC14YF or UC14YF2) ............................. 1
(5) Plastic case ............................................................... 1
Standard accessories are subject to change without
notice.
APPLICATIONS
Screw driving into indoor gypsum board
Driving and removing of small screws, small bolts,
etc.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch
and pull out the battery. (Fig. 1)
2. Battery installation
Insert the rechargeable battery, making sure that
the latch is on the trigger switch side of the handle.
(Fig. 1)
Handle
Rechargeable
battery
CHARGING
Before using the automatic screwdriver, charge the
battery as follows.
1. Connect the charger's power cord to an AC outlet.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals).
2. Insert the battery into the charger.
Position the battery so that the nameplate faces
toward the nameplate of the charger and push in
the battery until it contacts the bottom plate. (See
Figs. 2 and 3.)
CAUTION
If the batteries are inserted in the reverse direction,
not only recharging will become impossible, but it
may also cause the fuse to blow, or problems in
the charger such as a deformed recharging termi-
nal.
Insert
Pull out
Latch
Fig. 1
Nameplate
Latch
Rechargeable
battery
Insert
3. Charging
When inserting a battery in the charger, charging
will commence and the pilot lamp will light con-
tinuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals.) (See
Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown
in Table 1, according to the condition of the charger
or the rechargeable battery.
English
Rechargeable
battery
Fig. 2
Hole for connecting
d
the rechargeable
battery
Pilot lamp
Fig. 3
4