Rump Steak With Spring Onion And Herb Sauce (4 Persons); Cleaning & Maintenance; Storage - Silvercrest SKG 2000 A1 Bedienungsanleitung

Rump Steak with Spring Onion and
Herb Sauce (4 persons)
500 g lean rump steak (125 g each)
120 g margarine
1 tsp. Worcestershire sauce
1 finely chopped garlic clove
4 tbsp. finely chopped parsley
4 finely chopped spring onions
1. Mix the margarine and the Worcestershire sauce
in a small bowl. Mix in the garlic, parsley and
spring onions.
2. Warm the appliance up (Heat level M).
3. Grill the steak for 3 minutes at heat level M,
afterwards smear it with the spring onion & herb
sauce and then cook it for a further 4 minutes at
heat level I. Collect the dripping herb sauce with
o
the oil drip pan .
4. After they finish grilling, let the steaks rest briefly
and cut into thin strips against the grain. Arrange
the meat on a pre-heated serving plate, pour the
melted herb sauce from the oil drip pan
the cut meat.
Cleaning & Maintenance
Injury hazard!
Before cleaning, unplug the appliance and wait till
it has completely cooled down. Never attempt to
clean the appliance under running water and never
dip it in water.
Caution! Property damage!
So as not to destroy the nonstick coating or other
surfaces, do not use any aggressive detergents,
rough sponges or sharp objects for cleaning.
For normal cleaning, you can remove the grilling
i
hot plates from the appliance.
• For this purpose, press the hot plate fixing
springs
plates
• Rinse the hot plates
tral detergent.
• In case the grill surface has become heavily in-
crusted, keep a wet cleaning cloth on the hard
residual matter for a while to soak the layer.
The grill plates
dishwasher!!
• Wash the grease catchment bowl
water and a neutral detergent.
To clean the external surface of the appliance, use
a wet cloth.
Before using the Contact Grill again, make sure that
all components are completely dry.

Storage

o
over
You can store away the Contact Grill in horizontal
or upright position. Your Contact Grill has an inte-
grated compartment for storing the power cord at
the bottom of the housing. You can wind up the po-
wer cord in it when the appliance is not in use. This
way you can prevent the power cord from getting
entangled or soiled or from becoming a likely cause
of accidents.
- 7 -
t
slightly backwards to release the hot
i
.
i
with hot water and a neu-
i
can even be washed in the
o
with hot