Hazards Due To Repetitive Motions; Risks Associated With Accessories; Hazards In The Work Environment; Hazards Due To Dust And Vapours - Parkside PDKS 6.0 A1 Bedienungs- Und Sicherheitshinweise

General safety rules
Hold the machine correctly: be prepared
to counteract typical or sudden movements –
keep both hands ready.
Be sure your body is well balanced and you
maintain a solid grip.
Prevent injuries from cutting: Avoid con-
tact with the saw blade when the machine is
connected to the air supply. Wear protective
equipment such as gloves, apron and helmet.
Uncontrolled machine movement can
cause injuries: Always be sure to hold the
guide plate (if attached) firmly against the
work piece.
Cutting with these machines will create sharp
edges. Wear gloves to protect your hands.
In the event of power failure release the start-
or stop control.
Only use the lubricants recommended by the
manufacturer.
Protective equipment such as safety goggles
must be used; suitable gloves and protective
clothing are recommended.
Be aware the rotating built-in tool will start up
after activating the start- and stop control.
Hazards due to
repetitive motions
When using circular, oscillating or reciprocating
saws for work related tasks the operator may
experience discomfort of the hands and arms,
as well as the neck and shoulders or other
body parts.
When using circular, oscillating or reciprocating
saws the operator should maintain a comfortable
posture, ensuring a secure grip and avoiding
uncomfortable postures or postures making it
difficult to maintain balance. The operator should
change his posture when working for extended
periods to help prevent discomfort and fatigue.
If the operator experiences symptoms such as
persistently or repeatedly feeling unwell, discom-
fort, palpitations, pain, tingling, numbness, a
burning sensation or stiffness, these warning signs
should not be ignored. The operator should con-
sult a suitably qualified healthcare professional.
8 GB
110140_par_Druckluft-Saege PDKS 6.0 A1_content_PL_HU_SI_CZ_SK.indd 8
Risks associated with
accessories
Disconnect circular, oscillating and reciprocating
saws from power before installing or replacing
tools or accessories.
Only use accessory and material sizes and
types recommended by the manufacturer of the
circular, oscillating or reciprocating saw. Never
use other sizes and types of accessories and
materials.
Avoid direct contact with accessories before
and after using the equipment, as these may
be warm or sharp.
Inspect the saw blade prior to use. Do not use
saw blades which may have been dropped or
with chipped, cracked or otherwise defective
parts.
Hazards in the work
environment
Slipping, tripping and falling are the main causes
of injuries at the workplace. Keep in mind that
surfaces may have become slippery during
machine use, and remember tripping hazards
caused by the air- or hydraulic hose.
Proceed with caution in unfamiliar surroundings.
There may be hidden dangers due to electrical
cables or other supply lines.
These circular, oscillating or reciprocating saws
are not suitable for use in explosive environments
and are not insulated against contact with elec-
tric lines.
Verify there are no electric lines, gas lines, etc.
which may pose a hazards if damaged by use
of this equipment.
Hazards due to dust
and vapours
Dust and vapour produced when using circular,
oscillating and reciprocating saws can be dan-
gerous to the health (e.g. cancer, birth defects,
asthma and / or dermatitis; it's imperative to
08.07.15 10:57