Troubleshooting - Silvercrest SIKP 2000 B2 Bedienungsanleitung

Troubleshooting

PROBLEM
The appliance does not
function. The control lamp
"Power 4 does not glow.
The appliance does not
start the cooking process.
Shown in the display 8
is E01.
Shown in the display 8
is E02.
Shown in the display 8
is E03.
Shown in the display 8
is E05.
Shown in the display 8
is E06.
Shown in the display 8
is E07.
Shown in the display 8
is E08.
SIKP 2000 B2
POSSIBLE CAUSE
The plug 2 is not connected.
The appliance is damaged.
There is no cookware on the
cooking area 1.
The cookware is not suitable
for induction cooking areas.
The appliance is not being
supplied with enough voltage
(<160 V)..
The appliance is being sup-
plied with too much voltage (>
270 V).
There is a short circuit inside
the appliance!
The appliance is too hot (in
power levels mode)!
The temperature sensor under-
neath the cooking area 1 is
defective or there is a short
circuit..
The appliance is too hot (in
Temperature-Mode)!
The temperature sensor is
defective.
POSSIBLE SOLUTIONS
Connect the appliance to a mains
power socket.
In this case, contact Customer
Services.
Place suitable cookware on the
cooking area 1.
Use suitable cookware (see chapter
"Suitable Cookware")
Check and ensure that the appli-
ance is connected to a properly
installed mains power socket with
220 - 240V, 50 Hz.
Check and ensure that the appli-
ance is connected to a properly
installed mains power socket with
220 - 240V, 50 Hz.
Immediately disconnect the plug
2 from the mains power socket
and contact the Customer Services
department!
Disconnect the plug 2 from the
mains power socket and wait until
the appliance has cooled down.
Disconnect the plug 2 from the
mains power socket and contact
the Customer Services department.
Disconnect the plug 2 from the
mains power socket and wait until
the appliance has cooled down.
Disconnect the plug 2 from the
mains power socket and contact
the Customer Services department.
GB
13