AL-KO 4705 E Betriebsanleitung Seite 20

en
For a short lawn, slide the lever in the di-
rection of the front wheel.
For a longer lawn, slide the lever in the
direction of the rear wheel.
2. Allow the lever to engage.
Single wheel quick adjustment
Always adjust both axles to the same
cutting height.
1. To unlock, press the lever to the side and
hold. (1b, 1c)
For a short lawn, slide the lever in the di-
rection of the front wheel.
For a longer lawn, slide the lever in the
direction of the rear wheel.
2. Allow the lever to engage.
Single wheel adjustment
1. Loosen the wheel bolt. (1d)
2. Insert the wheel bolt in the hole for the desired
cutting height.
3. Tighten the wheel bolt.
4. Make sure all wheels at the same hole posi-
tion.
Working height adjustment (option)
Button adjustment
1. Hold both buttons on the upper handle bar
pressed and adjust to the desired position. (5)
2. Release the buttons so that the upper handle
bar engages.
Clamp adjustment
1. Hold the upper handle bar firmly and release
both clamps. (5)
2. Move the upper handle bar to the desired po-
sition and close the clamps.
Attaching the grass catcher
CAUTION!
Risk of injury!
Remove or replace the grass catcher
only while the motor is switched off and
the cutting blade has stopped.
1. Lift up the baffle plate and hang the grass cat-
cher into the holders.
Fill level indicator (option)
The level indicator is pressed upwards by the air
stream during mowing( 2a). If the grass catcher is
20
full, the level indicator lies flat on the box (2b). The
grass catcher needs to be emptied.
Emptying the grass catcher
1. Lift the baffle plate. (3)
2. Unhook the grass catcher and remove it to the
rear.
3. Entity the grass catcher.
4. Lift up the baffle plate and hang the grass cat-
cher back into the holders.
Establishing the mains connection
1. Insert the mains plug of the unit connecting
line into the switch/plug combination. (6)
2. Secure the unit connecting cables with the ca-
ble tension relief. (7)
The loop of the mains cable must be long
enough so that the cable tension relief
can glide from one side to the other.
Starting the motor
Start the lawn mower only on level ground and
not in high grass. The ground must be free from
foreign objects, such as stones. Do not lift or tilt
the lawn mower to start it.
1. Keep the start switch of the switch/plug com-
bination pressed. (8, 8a, 8b, 8c)
2. Pull the safety bar towards the handle bar and
hold it there. (8, 8a, 8b, 8c)
3. Release the start button.
Switching off the engine
1. Release the safety bar / handle.
2. Wait until the cutting blade stops.
Wheel drive (option)
CAUTION!
Engage the transmission only when the
motor is running.
Switching on the wheel drive
1. Press and hold the transmission control lever
against the upper handle bar - the transmis-
sion control lever does not engage. (9)
Wheel drive is switched on.
Switching off the wheel drive
1. Release the transmission control lever. (9)
Wheel drive is switched on.
Operation
469494_b