Special Product Features - Ryobi ETMS1825 Bedienungsanleitung

GB
FR DE ES
RULES FOR SAFE OPERATION
Before using the machine always check for possible
damage. Every time you want to use the machine,
make sure that all safety devices and protective
guards are checked carefully for proper function.
Check to see that all moving parts work properly and
do not jam. All parts must be correctly installed and
meet all conditions necessary for the proper operation
of the tool.
Damage protection devices or parts must be repaired
or replaced by a qualified specialist. Have damaged
switches replaced by a service centre. Do not operate
the machine if the switch can not be turned ON or
OFF. Do not operate the machine with a damaged
cord or plug or after the machine malfunction has
been dropped or damaged in any manner.
Keep handles free of oil and grease.
RISK OF INJURY BY NOISE!
Wear hearing protection.
Make sure the riving knife is not bend. A bent riving
knife will push the work piece against the side of the
saw blade, causing noise.
Voltage
Fuse protection
Power
Protection class
Degree of protection
Saw blade speed
Saw blade diameter
Dimensions
Machine in packing
- Length x width x height
Maximum work piece cross section
- 90° x 90°
- 90° x 45°
- 45° x 90°
- L45° X 45°
R45° X 45°
Cutting capacities in the table saw
IT NL PT DK SE FI NO RU PL CZ
English

SPECIAL PRODUCT FEATURES

Quick change over from crosscut saw mode to table
saw mode.
93° cutting angle range for bevel cut (48° left through
45° right) with five preset stops.
110° cutting angle range for miter cut (50° left through
60° right) with ten preset stops.
Perfect for mobile use because of its low weight and
small dimensions.
Sturdy cast aluminium construction for precision cuts.
TCT saw blade.
Installation of auxiliary fence possible.
A restart protection prevents restarting of the machine
when the power is restored after an interruption of the
power supply.
SPECIFICATIONS
3
HU RO LV LT EE
V~
A
W
IP
-1
min
mm
mm
mm
mm
mm
mm
mm
mm
HR SI SK GR TR
230V (50Hz)
10(time-lag)
1800
20
II
5000
254
700 x 585 x 420
70 x 110
50 x 100
40 x 90
35 x 50
40 x 90
40