Checking The Battery Charging Level; Operation; Adjusting Rear Handle Vertical Angle; Adjusting Trimmer Head Angle - FLORABEST FALHS 40-Li A1 Originalbetriebsanleitung

Charging status LEDs
Green LED flashing Charger ready
Red LED Battery pack charging
continuously lit
Green LED Battery pack fully charged
continuously lit
Red and green Battery pack defect
LEDs flashing
Red and green LEDs Battery pack too cold or
continuously lit warm
Checking the battery charging
Q
level
Press the battery charging level button
o
check the charging level of the battery
pack . The charging level will be shown
18
on the battery level indication light
4 Green LEDs Battery pack fully charged
continuously lit
3 Green LEDs Battery pack 75% charged
continuously lit
2 Green LEDs Battery pack 50% charged
continuously lit
1 Green LED Battery pack 25% charged
continuously lit
1 Green LED Low battery charging level
flashing
Charge the battery pack
o
when it is at medium or low battery charging
level.

Operation

Q
CAUTION! RISK OF INJURY!
Keep your hands away from the tool when
u
the product is in operation.
to
19
.
21
18
before operation
Adjusting rear handle vertical
Q
angle
WARNING!
The length of the pole extension is limited!
u
Stop pushing / pulling as soon as you feel a
resistance!
Extend the extension only to the length
u
required to reach the hedges being trimmed!
Do not attempt to use the product at a length
which does not allow you to achieve proper
footing and balance at all times!
1. Disengage the locking lever
2. Adjust the length by pulling / pushing the
pole extension
12
(see Fig. E).
3. Engage the locking lever
secure the pole extension

Adjusting trimmer head angle

Q
Adjust tilt angle of trimmer head to fit the operation
conditions.
1. Press the unlock buttons
hold them in position.
2. Adjust the trimmer head to the desired
position until the unlock buttons
position (see Fig. F).

Harness

Q
WARNING!
Always attach the product to the harness.
u
Do not carry it only with your hands!
Do only place the harness over one shoulder
u
to quickly remove it in case of emergency!
The harness 8 helps the operator to carry the
product.
1. Lift the product and hold it firmly while
placing the harness over your right shoulder
(see Fig. G).
2. Ensure the position of the product is properly
balanced.
3. Adjust the length of the harness to the desired
position.
4. In case of emergency release the on / off
switch and remove the harness
3
your shoulder.
.
11
out of / into the pole
10
afterward to
11
in position.
12
on both sides and
14
snap in
14
from
8
GB 15