Troubleshooting; Warranty - EGO HTA2000 Handbuch

TROUBLESHOOTING

EN
PROBLEM
Hedge Trimmer does
not work.
Excessive vibration or
noise.

WARRANTY

EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
12
HEDGE TRIMMER ATTACHMENT — HTA2000
CAUSE
◾
The battery pack is not attached to the
hedge trimmer.
◾
No electrical contact between the hedge
trimmer and battery.
◾
The battery pack is depleted.
◾
The lock-off button is not depressed
before pressing the trigger.
◾
The battery pack or power head is too hot.
◾
The blade is jammed.
◾
The hedge trimmer is not well connected
with the power head.
◾
Dry or corroded blades.
◾
Blades or blade support is bent.
◾
Bent or damaged teeth.
◾
Loose blade bolts.
SOLUTION
◾
Attach the battery pack to the hedge
trimmer.
◾
Remove battery, check contacts and
reinstall the battery pack.
◾
Charge the battery pack.
◾
Press down the lock-off lever and hold
it, then depress the trigger to turn on
the tool.
◾
Allow the battery pack or power head
to cool until the temperature drops
below 152°F (67°C).
◾
Remove the battery pack from the
tool. Remove the obstruction carefully
and then reinsert the battery and
restart the tool.
◾
Disconnect the hedge trimmer from
the power head. Reconnect them
following the section"INSTALLING AN
ATTACHMENT TO THE POWER HEAD"
in PH1400E operator's manual.
◾
Lubricate the blades.
◾
Replace with a new blade or support.
Contact EGO service center for blade
or support replacement.
◾
Replace with a new blade or support.
Contact EGO service center for blade
or support replacement.
◾
Tighten the blade bolts. Using a 3mm
wrench, (not included), turn the bolt
clockwise to tighten.