Inhaltsverzeichnis
Werbung
È
CRANKCASE AND CRANKSHAFT
5PA41720
É
5PA41730
5PA41740
5PA41750
Crankshaft
1. Install:
Crankshaft 1
G
Use the crankshaft installing tool 2, 3, 4.
Crankshaft installing pot 2:
YU-90050/90890-01274
Crankshaft installing bolt 3:
YU-90050/90890-01275
Adapter (M10) 4:
YM-1277/90890-01277
È For USA and CDN
É Except for USA and CDN
NOTE:
Hold the connecting rod at top dead center
G
with one hand while turning the nut of the
installing tool with the other. Operate the
installing tool until the crankshaft bottoms
against the bearing.
Before installing the crankshaft, clean the
G
contacting surface of crankcase.
Apply the lithium soap base grease on the oil
G
seal lip.
CAUTION:
Do not use a hammer to drive in the crank-
shaft.
2. Check:
Shifter operation
G
Transmission operation
G
Unsmooth operation → Repair.
3. Apply:
Sealant
G
On the right crankcase 1.
Quick gasket
ACC-QUICK-GS-KT
YAMAHA Bond No. 1215:
90890-85505
NOTE:
Clean the contacting surface of left and right
crankcase before applying the sealant.
4 - 57
ENG
®
:
Werbung
Inhaltsverzeichnis
