Maintenance And Cleaning; Warranty - Parkside IAN 100086 Originalbetriebsanleitung

Operation / Maintenance and Cleaning / Warranty
Hard screwdriving conditions (into metal):
P articularly high torques can occur, for example
with metal screws tightened by socket tool bits.
Select a lower rotation speed.
Soft screwdriving conditions (e.g. into
soft wood):
Y ou should also select a low speed in order not to
damage the wood workpiece surface through con-
tact with the metal screw head. Use a countersinker.
When drilling into wood, metal and other
materials, take note of the following advice:
W ith small diameter drill bits use a high drill
speed. For large diameter drill bits, use a low
drill speed.
F or hard materials, select a low drill speed.
For soft materials, select a high drill speed.
S ecure or fix down the workpiece (if possible)
in a clamp or vice.
M ark the intended position of the hole with a
centre punch or a nail and select a low drill speed
for drilling.
T ake the rotating drill bit out of the hole frequently
so that swarf or drill dust can be re-moved and
the hole and tool is ventilated.
Drilling in metal:
U se a metal drill bit (HSS). For the best results,
you should cool the bit with oil. Metal drill bits
can also be used to drill into plastic.
Drilling in stone:
U se a circular shafted masonry drill bit with a
hardened metal tip.
Drilling in wood:
N ormally you should use a wood drill with a
centring point. For deep holes, use an auger type
bit. For large diameter holes, use a forstner bit.
You can screw small screws into soft wood
without the need for pre-drilling.

Maintenance and Cleaning

RISK OF INJURY! Switch
the device off, unplug from the mains socket and
12 GB/IE
remove the battery before performing any work on
the device.
The cordless drill is maintenance-free.
Always keep the device clean, dry and free of
oil or grease.
Use a dry cloth to clean the housing.
If the connection cable needs
to be replaced, this repair must be performed
by the manufacturer or a representative to pre-
vent safety hazards.
When storing a lithium-ion battery for extended
periods, regularly check the charge. The optimal
charge is between 50 % and 80 %. The optimal
storage climate is cooling and dry.
Note: Spare parts not listed (e.g. carbon brushes,
switches) can be ordered through our call centre.

Warranty

The warranty for this appliance is for 3
years from the date of purchase. The ap-
pliance has been manufactured with care
and meticulously examined before deliv-
ery. Please retain your receipt as proof
of purchase. In the event of a warranty
claim, please make contact by telephone
with our Service Department. Only in this
way can a post-free despatch for your
goods be assured.
The warranty covers only claims for material and
maufacturing defects, but not for transport damage,
for wearing parts or for damage to fragile compo-
nents, e.g. buttons or batteries. This product is for pri-
vate use only and is not intended for commercial use.
The warranty is void in the case of abusive and im-
proper handling, use of force and internal tampering
not carried out by our authorized service branch. Your
statutory rights are not restricted in any way by this
warranty.
The warranty period will not be extended by repairs
made unter warranty. This applies also to replaced