IKEA FROSTIG Bedienungsanleitung Seite 17

ENGLISH
Problem
Water flows on the floor.
Temperature cannot be set.
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
If your appliance still is not
working properly making the
above checks, contact the
Authorised Service Centre. You
can find the list at the end of this
manual.
Possible cause
The melting water outlet is
not connected to the evap-
orative tray above the
compressor.
The Shopping function is
switched on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The Shopping function is
switched on.
There is no cold air circula-
tion in the appliance.
Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Solution
Attach the melting water outlet
to the evaporative tray.
Switch off Shopping manually,
or wait until the function resets
automatically to set the tem-
perature. Refer to " Shopping
function".
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and dis-
play shuts off for a short time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
Refer to "Shopping function".
Make sure that there is cold
air circulation in the appliance.
17