Ventilation; Starting-Up And Appliance Management; Before The First Use; Induction Principle - M-system MI-62 Bedienungsanleitung

Ventilation

The cooling system is fully automatic. The cooling fan starts with a low speed when the calories
brought out by the electronic system reach a certain level. The ventilation starts his high speed
when the hob is intensively used. The cooling fan reduces his speed and stops automatically
when the electronic circuit is cooled enough.

STARTING-UP AND APPLIANCE MANAGEMENT

Before the first use

Clean your hob with a damp cloth, and then dry the surface thoroughly. Do not use detergent
which risks causing blue-tinted colour on the glass surface.

Induction principle

An induction coil is located under each heating zone. When it is engaged, it produces a variable
electromagnetic field which produces inductive currents in the ferromagnetic bottom plate of the
pan. The result is a heating-up of the pan located on the heating zone.
Of course the pan has to be adapted:
 All ferromagnetic pans are recommended (please verify it thanks a little magnet): cast iron
and steel pans, enamelled pans, stainless-steel pans with ferromagnetic bottoms...

Are excluded: cupper, pure stainless-steel, aluminium, glass, wood, ceramic, stoneware...
The induction heating zone adapts automatically the size of the pan. With a too small diameter
the pan doesn't work. This diameter is varying in function of the heating zone diameter.
If the pan is not adapted to the induction hob the display will show [ U ].

Sensitive touch

Your ceramic hob is equipped with electronic controls with sensitive touch keys. When your finger
presses the key, the corresponding command is activated. This activation is validated by a
control light, a letter or a number in the display and/or a "beep" sound.
In the case of a general use press only one key at the same time.

Starting-up

You must first switching on the hob, then the heating zone:

Start-up/ switch off the hob:
Action
To start
Touch the key

Start-up/ switch off a heating zone:
Action
Zone selection
Increase power
Decrease power
Stop
If no action is made within 20 second the electronics returns in waiting position.
Control panel
Press key [ 0/I ]
Press key [ 0/I ]
Control panel
Press selection key from the zone
Press key [ + ]
Press key [ - ]
Press key [ - ]
51
Display
[ 0 ]
Nothing or [ H ]
Display
[ 0 ]
[ 1 ] to [ 9 ]
[ 9 ] to [ 1 ]
[ 0 ] or [ H ]