Sony LH61 Bedienungsanleitung Seite 45

Centering of workpiece
s =100

X

X
SET
L
Contact
A
X
START
H
A B
C L
A B
C
Workpiece
Center
A
Workpiece
Center
Operating Procedure
Select the X-axis.
Note
If an axis is not selected, all axes are
switched simultaneously.
Set the absolute mode (ABS).
(The spot position is displayed.)
The ABS indicater lights.
Select the X-axis again.
Press the LOAD key.
The arrow indicater flashes.
Touch the surface A of the workpiece with the
feeler of the Touch Sensor. On contact the
buzzer beeps and counting starts.
The arrow indicater goes out.
Select the X-axis.
Press the HOLD key. It is ready for holding the
display "s".
The arrow indicater goes out.
Move the Touch Sensor to touch the surface
B. On contact the buzzer beeps and the
display is held.
The arrow indicater lights.
Press the 1/2 key.
The HOLD mode is released.
The value displayed hereupon is the distance
from the workpiece center C.
The arrow indicater goes out. It is ready for
centering.
Move the Touch Sensor toward the workpiece
center C.
The position where the displayed value is "0"
is the center.
s
C
B
Direction of movement and polarity


Flashes
Buzzer
Buzzer
Llights up
Display
INC
mm
ABS
mm
ABS
mm
ABS
mm
ABS
mm
Counting
(The arrow indicator flashes.)
ABS
mm
ABS
mm
Counting
ABS
mm
37