Yamaha M2500 Bedienungsanleitung Seite 31

Rear panel
E ST OUT, MONO/C OUT jacks
These are XLR-3-32 output jacks (balanced) that out-
put the signal of the stereo/monaural master section.
Nominal output level of each jack is +4 dB. The pin
wiring is as follows.
Female XLR plug
F MONITOR OUT jacks
These are XLR-3-32 output jacks (balanced) that out-
put the signal of the stereo/monaural master section,
or the monitor source that is selected by the control
panel. Nominal output level of each jack is +4 dB.
The pin wiring is as follows.
Female XLR plug
Note: When outputting the monitor source
selected by the control panel, only the MONITOR
OUT L/R jacks are used.
G SUB IN MATRIX jacks
These are 1/4" phone jacks (unbalanced) for mixing a
line level signal from an external device into the
MATRIX bus. Nominal input level is +4 dB. The pin
wiring is as follows.
1/4" phone plug
H SUB IN ST L/R, MONO/C jack
These are 1/4" phone jacks (unbalanced) for mixing a
line level signal from an external device into the STE-
REO bus L/R and MONO/C bus respectively. Nomi-
nal input level is +4 dB. The pin wiring is as follows.
1/4" phone plug
28
M2500—Owner's Manual
I INSERT I/O G1/A7–G8/A14 jacks
2 (hot)
3 (cold)
1 (ground)
J INSERT I/O AUX jacks
2 (hot)
3 (cold)
1 (ground)
K INSERT I/O ST L/R, MONO jacks
Tip (send)
Sleeve (ground)
Tip (send)
Sleeve (ground)
These are TRS phone jacks for inserting an external
effect processor into each output channel of the G1/
A7–G8/A14 section. Nominal input level is 0 dB. The
pin wiring is as follows.
Tip (send)
Ring (return)
1/4" TRS phone plug
Sleeve (ground)
Connect to INSERT I/O jack
These are TRS phone jacks for inserting an external
effect processor into each output channel of the AUX
1–6 section. Nominal input level is 0 dB. The pin wir-
ing is as follows.
Tip (send)
Ring (return)
1/4" TRS phone plug
Sleeve (ground)
Connect to INSERT I/O jack
These are TRS phone jacks for inserting an external
effect processor into each output channel of the ste-
reo/monaural master section. Nominal input level is
0 dB. The pin wiring is as follows.
Tip (send)
Ring (return)
1/4" TRS phone plug
Sleeve (ground)
Connect to INSERT I/O jack
Tip (send)
1/4" phone plug
To processor's input
Sleeve (ground)
Tip (return)
1/4" phone plug
From processor's output
Sleeve (ground)
Tip (send)
1/4" phone plug
To processor's input
Sleeve (ground)
Tip (return)
1/4" phone plug
From processor's output
Sleeve (ground)
Tip (send)
1/4" phone plug
To processor's input
Sleeve (ground)
Tip (return)
1/4" phone plug
From processor's output
Sleeve (ground)