Impedance Selector Switch - Yamaha DSP-A2 Bedienungsanleitung

PREPARATION
Note on main speaker connections:
One or two speaker systems can be connected to this unit. If
you use only one speaker system, connect it to either the
SPEAKERS A or B terminals.

IMPEDANCE SELECTOR switch

WARNING
Do not change the IMPEDANCE SELECTOR switch
setting while the power to this unit is on, otherwise this
unit may be damaged.
IF THIS UNIT FAILS TO TURN ON WHEN THE
STANDBY/ON SWITCH IS PRESSED:
The IMPEDANCE SELECTOR switch may not be set to
either end. If so, set the switch to either end when this unit
is in the standby mode.
(Europe model)
SPEAKERS
CAUTION
SEE INSTRUCTION MANUAL FOR CORRECT SETTING.
MAIN
A
B
IMPEDANCE SELECTOR
22
REAR
AC OUTLETS
SWITCHED
I00W MAX.
( SURROUND )
TOTAL
A
CENTER : 4ΩMIN. / SPEAKER
FRONT : 6ΩMIN. / SPEAKER
REAR : 6ΩMIN. / SPEAKER
MAIN A OR B: 4ΩMIN. / SPEAKER
A B : 8ΩMIN. / SPEAKER
CENTER : 8ΩMIN. / SPEAKER
FRONT : 8ΩMIN. / SPEAKER
REAR : 8ΩMIN. / SPEAKER
B
MAIN A OR B: 8ΩMIN. / SPEAKER
A B : I 6ΩMIN. / SPEAKER
SET BEFORE POWER ON
IMPEDANCE SELECTOR
Note on a subwoofer connection:
You may wish to add a subwoofer to reinforce low frequencies
or to output low bass sound from the subwoofer channel when
reproducing discrete signals.
When using a subwoofer, connect the SUBWOOFER terminal
of this unit to the INPUT terminal of the subwoofer amplifier,
and connect the speaker terminals of the subwoofer amplifier
to the subwoofer.
With some subwoofers, including the Yamaha Active Servo
Processing Subwoofer System, the amplifier and subwoofer
are in the same unit. Such a subwoofer needs only the
connection between the SUBWOOFER terminal of this unit
and the INPUT terminal of the subwoofer.
(Refer to page 23 for details about the SUBWOOFER
terminal.)
Select the position whose requirements your speaker system
meets.
(Upper position)
Center: The impedance of the speaker must be 4Ω or higher.
Front effect:
The impedance of each speaker must be 6Ω or
higher.
Rear: The impedance of each speaker must be 6Ω or
higher.
Main: If you use one pair of main speakers, the impedance
of each speaker must be 4Ω or higher.
If you use two pairs of main speakers, the impedance
of each speaker must be 8Ω or higher.
(Lower position)
Center: The impedance of the speaker must be 8Ω or higher.
Front effect:
The impedance of each speaker must be 8Ω or
higher.
Rear: The impedance of each speaker must be 8Ω or
higher.
Main: If you use one pair of main speakers, the impedance
of each speaker must be 8Ω or higher.
If you use two pairs of main speakers, the impedance
of each speaker must be 16Ω or higher.