Product Specification; Intended Use; Operating Controls - Bosch AKE 30-19 S Handbuch

F016 L70 532 - Buch Seite 3 Freitag, 18. April 2008 9:07 09

Product Specification

Chain saw
Part number (typ)
Tool-less chain tensioning (SDS)
Rated power
Chain speed (no load)
Chain bar length
Nose sprocket
Kickback Brake
Run down brake
Chain type
Drive link thickness
Amount of drive links
Oil reservoir capacity
Automatic oiler
Metal gripping teeth
Weight without mains cable. approx. **
Protection class
**measured with chain bar and chain
Note: Please observe the order number of your machine. The trade names of individual machines can vary.
Inrush currents cause short-time voltage drops. Under unfavourable power supply conditions, other equipment may
be affected. If the system impedance of the power supply is lower than 0.25 Ohm, disturbances are unlikely to occur.

Intended Use

The chain saw is intended for sawing of trees, tree
trunks, branches, wooden beams, planks, etc. Cuts
can be sawed with or across the grain. This product
is not suitable for sawing mineral materials.
Introduction
This manual gives instructions on the correct as-
sembly and safe use of your chain saw. It is impor-
tant that you read these instructions carefully.
Delivered Items
Carefully remove the machine from its packaging
and check for complete contents:
– Chain saw
– Cover plate
– Chain
– Chain bar
– Chain guard
– Chain oil (80 ml)
– Operating instructions
When parts are missing or damaged, please contact your
dealer.
20 • F016 L70 532 • 08.04
AKE 35-19 PRO
0 600 836 7..
[W] 1900
[m/s] 13
[cm] 35
3/8" - 91
[mm] 1.3 (0.05")
52
[ml] 200
[kg] 4.6
/ II

Operating Controls

A
1 Rear handle
2 On/Off switch
3 Lock-off button
4 Oil filler cap
5 Activation lever for kickback brake
(hand guard)
6 Deactivation mark for kickback brake
7 Front handle
8 Nose sprocket
9 Chain guard
10 Chain
11 Chain bar
12 Gripping teeth
13 Tensioning ring (red)
14 Locking knob
15 Cover plate
16 Chain tensioning catch
17 Fastening bolt
18 Guide fins for chain bar
19 Oil outlet
20 Symbol for rotation and cutting direction
21 Drive sprocket
22 Chain catch bolt
23 Mains plug**
24 Serial Number
**Country specific
Not all of the accessories illustrated or described are
included as standard delivery.
English - 3
AKE 40-19 PRO
0 600 836 8..
1900
13
40
3/8" - 91
1.3 (0.05")
57
200
4.7
/ II