Battery Check - Olympus C-5050ZOOM Anleitung

Memory gauge
The memory gauge lights up when you take a still picture. When the gauge is
lit, the camera is saving a picture to the card. The memory gauge indication
changes as shown below depending on the shooting status. The indication is
not displayed during movie recording.
Shoot
Before shooting
(Gauge is off)
En

Battery check

If the remaining battery power is low, the battery check indication on the
control panel and monitor changes as follows when the camera is turned on
or while the camera is in use.
Battery check
No indication
12 En
One picture
taken
(Lit)
Control panel
Lights Lights (green)
(Goes off after a while)
Blinks
The green lamp and orange lamp at the
side of the viewfinder blink. (The control
panel turns off automatically.)
Shoot
More than
two taken
(Lit)
Monitor
Remaining power level: high
Blinks (red) Remaining power level: low
Replace with new batteries.
Remaining power level:
exhausted
Replace with new batteries.
Shoot
Wait
No more pictures
can be taken
(Fully lit)
Wait a while before
taking the next shot.
Status