Specifications; Standard Accessories - Hitachi DH 40MR Bedienungsanleitung

SPECIFICATIONS

Voltage (by areas)*
Pow er input
Capacity
No load speed
Full-load im pact rate
Weight (w ithout cord, side handle)
* Be sure to check the nam eplate on product as it is subject to change by areas.

STANDARD ACCESSORIES

(1) Case (M olded plastic) ............................................... 1
(2) Side Handle ................................................................ 1
(3) Stopper ........................................................................ 1
(4) Hexagon Bar Wrench (for 6 m m screw ) ............. 1
(5) Hexagon Bar Wrench (for 5 m m screw ) ............. 1
(6) Hexagon Bar Wrench (for 4 m m screw ) ............. 1
(7) Ham m er Grease A .................................................... 1
Standard accessories are subject to change w ithout
notice.
OPTIONAL ACCESSORIES (sold separately)
1. Through-hole drilling (Rotation + Ham m ering)
(1) Drill bit (SDS m ax shank)
Outer diam eter (m m )
16
19
22
25
28
32
38
40
2. Anchor hole drilling (Rotation + Ham m ering)
Drill bit (Taper shank)
(3) Cotter
(1) Drill bit (taper shank)
External dia.: 11, 12.3, 12.7,
14.3, 14.5,
17.5 m m
01e_dh40mr_e.p65
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
3. Large dia. hole boring (Rotation + Striking)
(1) Center pin
Overall length (m m )
340, 540
(2) Core bit
320, 520
370, 570
(3) Core bit shank
4. Drilling holes .... For drilling m etal and w ooden
(2) Taper shank
adapter
(SDS m ax shank)
6
950 W*
Drill bit: 40 m m
Core bit: 105 m m
240 – 480 m in -1
1320 – 2650 m in
6.5 kg
Taper shank
Application drill bit
adapter
M orse taper Drill bit (taper shank)
(No. 1) 11, 12.3, 12.7, 14.3, 14.5, 17.5 m m
Adapter for SDS-plus shank bit
(1) Drill bit (2) Adapter for SDS-plus
(SDS-plus shank)
(Guide (1) Center
(2) Core
plate) pin
bit
Applied to core bits from 38 m m to 105 m m
Applied to core bits 32 m m and 35 m m
NOTE:
Do not use core bits 25 m m or 29 m m .
External dia. 25, 29, 32, 35, 38, 45, 54, 64, 79, 94,
105 m m
(w ith guide plate, not applicable to cores 25 m m
or 29 m m )
Applied to core bits above 38 m m
Applied to core bits below 35 m m
m aterials
13 m m drill chuck
(13VLA)
Chuck w rench
1/20/04, 2:13 PM
English
-1
shank bit
(SDS m ax shank)
(3) Core bit shank
(SDS max
shank)
Chuck adapter
(SDS m ax shank)
6