Help In Case Of Malfunction; Disposal - AL-KO COMBI-CARE 38 E comfort Betriebsanleitung

Water ingress can cause irreparable damage to the
motor and the safety pushbutton switch.
Clean the machine after each use (scraper, cloth,
„
etc.).
Remove the blade shaft (08)
1. Unscrew and remove the screw (1) of the bearing.
2. Fold up the bearing half (2).
3. Lift the blade shaft out of the lower bearing half
and pull it out of the drive side (3).
Install in reverse order.
Remove the blades (09)
Before removing the blades, check their instal-
lation position!
1. Unscrew and remove the hexagon bolt (1).
2. Carefully pull the ball bearing (2) off the shaft (8).
3. Pull the thrust ring (3), washer (4) and short
spacer tube (5) off the shaft.
4. Pull off the blades (6) and long spacer tubes one
after another.
Install in reverse order.
Removing the aerator roller
Remove the aerator roller and renew the steel spring
tines in the same way as the blade shaft.
18

Help in case of malfunction

Malfunction Help
Motor does not
Check the power cable and
„
start
the residual-current circuit
breaker
Push the operator presence
„
control towards the top han-
dlebar.
Select a lower working depth.
„
Shaft does not
Select a lower working depth.
„
rotate
Clear the blades
„
Contact a customer service
„
workshop
The motor loses
Select a lower working depth.
„
power
Renew worn blades.
„
Clean the housing
„
Mow the lawn (grass is too
„
long).
Poor scarifying
Select a lower working depth.
„
performance
Renew worn blades.
„
Machine is
Damaged blades.
„
not running
Contact a customer service
„
smoothly
workshop.
Machine is
vibrating
Malfunctions that cannot be rectified using this table
must be attended to by an authorised specialist work-
shop.

Disposal

Do not dispose of worn-out equipment,
spent batteries or rechargeable batteries
in domestic waste.
The packaging, equipment and accessories are made
from recyclable materials, and must be disposed of
accordingly.
Translation of the original instructions for use