RECARO Style Bedienungsanleitung Seite 25

How to operate your RECARO seat
8. Seat heating
Figure A
Press the action point of the switch to
switch on the heating.
After a warm-up period, the heating system
maintains a constant, pleasant temperature
in the seat and backrest cushions.
Press the switch in the opposite direction to
switch off.
Risk of electric shock and
overheating
There is a risk of electric shock if the
seat heating mats are damaged.
Therefore, do not place any sharp or
heavy objects on the seat or stand or
kneel on the seat.
Do not use decorative covers or any
other covers for your seat in order to
prevent it from overheating.
9. Adjusting the Airmatic lumbar
vertebrae support (lordosis)
Figure A
The region of the lumbar vertebral column
is placed under considerable strain when
sitting. Suitable support can prevent pain
and injury from arising. The RECARO seat
takes particular account of this with its
basin design and ergonomic upholstery.
Two inflatable air cushions are located
under the backrest cushion. You pump up
or empty the air cushions using the switch
on the cover.
Press the front of the switch to pump up
both air cushions. Press the rear of the
switch to empty both air cushions.
To shift the point of pressure of the lumbar
support upward, press the top of the switch.
To shift the point of pressure downward,
press the bottom of the switch.
Note!
Owing to the
specification of the backrest, very little
pumping is required.
high grade contour
10. Adjusting the sitting area length
Figure C
The front part of your RECARO seat is
equipped with a pull-out cushion section.
Sit on the seat in order to adjust the seat
cushion length. Lift your thighs slightly and
slide the cushion section forward to the
desired position. If you wish to shorten the
sitting area length, lift the cushion section
and pull it towards you.
23