Control Panel; Before Using The Hood - IKEA HOO E00 S Installationsanleitung

1. Control panel

2. Grease filters
3. Grease filter handles
4. Light above cooker (depending on model)
5. Telescopic flue
To clean the grease filter
Clean the grease filter once a month.
1. Disconnect the electrical power supply.
2. Remove the grease filters - Fig. 1:
a - push the handles backwards
b - and then downwards.
3. After cleaning the grease filter refit in reverse order,
making sure the entire extraction surface is covered.
Fitting or replacing the carbon filter:
Change the carbon filter every six months.
1. Disconnect the electrical power supply.
2. Remove the grease filters (Fig. 1 - a, b).
3. Fit the filters over the motor: make sure the pins R on the
manifold match the slots S, then turn clockwise until
locked.
4. Carry out in the reverse order to remove.
5. Refit the grease filters.
Replacing bulbs
1. Disconnect the electrical power supply.
2. Remove the grease filters (Fig. 1 - a, b).
3. Remove the burnt-out bulb.
Replace using 40W max E14 bulbs only.
4. Refit the grease filters.
Halogen lamps:
Use a small screwdriver or other
suitable tool to prise off the cover. Refit
the cover.
5. Use only max 40 W - E14 bulbs
or max 20 W halogen bulbs
(depending on the model),
taking care not to touch them
with your hands.
5019 618 33043/A
D GB F NL
CONTROL PANEL
Light switch.
The switch has two positions (lights OFF - lights ON).
To switch on the lights: move the switch to the right.
Extraction speed selection switch.
The extraction speed switch has different settings,
depending on the amount of steam and fumes.
To increase the extraction speed: move the switch to the
right.
Fig.2
Cleaning the hood
Warning! Failure to remove oil/grease (at least once a
month) could lead to fire.
Use a soft cloth with a neutral detergent. Never use abrasive
substances or alcohol.

Before using the hood

Please read these instructions carefully and keep them for
future reference, in order to ensure best use of your hood.
Packaging materials (plastic bags, polystyrene, etc.) can be
dangerous for children and should be kept well out of their
reach.
Make sure the hood has not been damaged during transport.
Installation and electrical connections must be carried out by
a qualified technician in compliance with the current local
regulations.
E P I GR
Fig.1
N
S DK
FIN