Housing And Sole Of The Iron; Storage; Troubleshooting; Disposal - Silvercrest SDBE 2600 A1 Bedienungsanleitung

■ Dry the sole of the iron
this, move the sole of the iron
several times over a towel or an old piece of
fabric.
■ Allow the steam iron to cool down before placing
it in storage.

Housing and sole of the iron

MORTAL DANGER!
► ALWAYS remove the plug before cleaning the
appliance. There is a risk of electric shock!
RISK OF INJURY!
► Allow the appliance to cool down before
cleaning it. Otherwise, there is a risk of burns!
CAUTION! PROPERTY DAMAGE!
► Do not use aggressive, abrasive or chemical
cleaning agents. They can damage the surface
and also lead to irreparable damage to the
appliance.
■ Clean the housing with a soft, dry cloth only.
■ Clean the sole of the iron
and a mild, non-scouring detergent.
■ Dry the appliance well before using it again.

Storage

Store the cooled-down appliance in a clean, dust-
free and dry location.
SDBE 2600 A1
thoroughly. To do
back and forth
using a damp cloth

Troubleshooting

The steam iron blasts out no steam/very
little steam:
The reserves of tap water/distilled water in the
steam iron are depleted. Fill the water tank (See
"Filling the water tank").
The steam iron does not get hot:
■ The steam iron is not plugged in or is not switched
on. Insert the plug into a wall power socket and
adjust the temperature control
ironing temperature.
■ The steam iron is defective. Arrange for the steam
iron to be repaired by qualified specialists.

Disposal

Never dispose of the appliance
in the normal domestic waste.
This product is subject to the
provisions of European Directive
2012/19/EU.
Dispose of the appliance through an approved
disposal centre or at your community waste facility.
Please observe applicable regulations. Please
contact your waste disposal facility if you are in
any doubt.
Dispose of all packaging materials in an
environmentally friendly manner.
to the desired
GB │ IE │ 21 ■