Closing The Door - AEG AGN2291 Benutzerinformation

Problem
The Pilot light flash-
es.
The Alarm light
flashes.
The compressor op-
erates continually.
The temperature in
the freezer is too
low.
The temperature in
the freezer is too
high.
There is too much
frost.

7.1 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
Possible cause
The appliance has no
power. There is no volt-
age in the mains socket.
The appliance is not
working properly.
The temperature in the
freezer is too high.
The temperature is not
set correctly.
The door is not closed
correctly.
The door has been
opened too frequently.
The product temperature
is too high.
The room temperature is
too high.
The temperature regula-
tor is not set correctly.
The Fast Freeze function
is switched on.
The temperature regula-
tor is not set correctly.
Many products are stored
at the same time.
Products are too near to
each other.
Food is not wrapped cor-
rectly.
The temperature regula-
tor is not set correctly.
3.
Solution
Connect a different electri-
cal appliance to the mains
socket.
Contact a qualified electri-
cian.
Contact a qualified electri-
cian.
Refer to "Excessive Tem-
perature Alarm"
Set a higher temperature.
Refer to "Closing the
door".
Do not keep the door
open longer than necessa-
ry.
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Decrease the room tem-
perature.
Set a higher temperature.
Refer to" Fast Freeze func-
tion".
Set a lower temperature.
Store less products at the
same time.
Store products so that
there is cold air circulation.
Wrap the food correctly.
Set a higher temperature.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH
61