Periodic Cleaning; Troubleshooting - AEG AGN2291 Benutzerinformation

60 www.aeg.com
This appliance contains hydrocar-
bons in its cooling unit; mainte-
nance and recharging must
therefore only be carried out by
authorized technicians.

6.2 Periodic cleaning

The equipment has to be cleaned regu-
larly:
• clean the inside and accessories with
lukewarm water and some neutral
soap.
• regularly check the door seals and
wipe clean to ensure they are clean
and free from debris.
• rinse and dry thoroughly.
Do not pull, move or damage
any pipes and/or cables inside
the cabinet.
Never use detergents, abrasive
powders, highly perfumed clean-
ing products or wax polishes to
clean the interior as this will dam-
age the surface and leave a
strong odour.
Clean the condenser (black grill) and the
compressor at the back of the appliance

7. TROUBLESHOOTING

WARNING!
Before troubleshooting, discon-
nect the mains plug from the
mains socket.
Only a qualified electrician or
competent person must do the
troubleshooting that is not in this
manual.
Problem
The appliance does
not operate. The Pi-
lot light does not
flash.
with a brush. This operation will improve
the performance of the appliance and
save electricity consumption.
Many proprietary kitchen surface clean-
ers contain chemicals that can attack/
damage the plastics used in this appli-
ance. For this reason it is recommended
that the outer casing of this appliance is
only cleaned with warm water with a little
washing-up liquid added.
After cleaning, reconnect the equipment
to the mains supply.
6.3 Defrosting
Your appliance is frost free. This means
that there is no buildup of frost when it is
in operation, neither on the internal walls
nor on the foods.
The absence of frost is due to the con-
tinuous circulation of cold air inside the
compartment, driven by an automatically
controlled fan.
Possible cause
The appliance is switched
off.
The mains plug is not
connected to the mains
socket correctly.
Take care of not to damage the
cooling system.
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.