Replacing The Fuse - Silvercrest SBTF 10 C2 Bedienungsanleitung

Replacing the fuse

GB
The hands-free set is equipped with a fuse. If the device
no longer works, check the fuse and replace if necessary.
Open the vehicle connector plug
fluted screw insert
if necessary – and remove it.
Remove the plug tip
out. Ensure that the spring
plug
Place a new fuse of type F2AL/250V into the vehicle
connector plug
of the fuse that is slightly protruding
screw insert that you removed earlier
Danger!
Replace the fuse only with another of the same rating
as that given on the ratings plate. Fuses with a different
rating may cause fire. Smoke resulting from such a fire
is poisonous.
Note:
If these measures do not correct the problem, please con-
tact the appropriate service partner for your country.
14
gently anticlockwise – with pliers
A
B
does not accidentally jump out and become lost.
, place the plug tip
D
from the fuse
C
in the vehicle connector
D
C B A
by turning the
and pull the fuse
onto the end
B
and screw the
C
back in.
A
SBTF 10 C2