Connections And Preparations; Unpacking; Inserting The Batteries Into The Remote Control; Installing Batteries - Sony VPL-HW55ES Bedienungsanleitung

Connections and Preparations

This section describes how to install the projector and screen, how to connect the
equipment from which you want to project the picture, etc.

Unpacking

Check the carton to make sure it contains the following items:
• Remote control (1) and
Size AA (R6) manganese batteries (2)

Inserting the batteries into the remote control

CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the manufacturer.
When you dispose of the battery, you must obey the law in the relative area or country.

Installing batteries

Two size AA (R6) batteries are supplied for Remote Control.
To avoid risk of explosion, use size AA (R6) manganese or alkaline batteries.
Insert the batteries E side first as shown in the illustration.
Inserting them forcibly or with the polarities reversed may
cause a short circuit and may generate heat.
Push and slide to open.
• AC power cord (1)
• Lens cap (1)
When you have purchased the projector,
the lens cap is put onto the lens.
Remove this lens cap when you use the
projector.
• 3D glasses (2)
• Pouch for the 3D glasses (2)
• USB charging cable (APY5244010020/
SONY) (1.2 m) (2)
• Conversion cable (LAN(M)-MD03(J)/
SONY) (18 cm) (1)
• Operating Instructions (this manual)
• Operating Instructions for the 3D
glasses (1)
11
GB