Using The Display; Display Information - Sony ST-D777ES Bedienungsanleitung

Using the Display Z
DISPLAY DISPLAY MODE

Display Information

You can check the status of this tuner and the
information about the programme using the display.
When you tune in the DAB station
Each time you press DISPLAY, the display changes as
follows:
Preset number/Channel label
(Normal display)
r
Ensemble label
r
PTY
r
Dynamic label (Radio Text)
r
Clock time
r
Frequency
r
Component label
1) Only when you tune in the secondary component. In this
case, the normal display is set to component label.
z
When "SC" appears in the display
You can tune in the secondary component or another
service of the dual channel. For details, see page 11.
z
When "STEREO" appears in the display
The current programme is broadcasted in the stereo/
joint (intensity) stereo mode.
When you tune in the FM or AM station
Each time you press DISPLAY, the display changes as
follows:
2) Only when you tune in a FM RDS station
Customizing the display
You can select the appearance of the display from one
of the following four display modes.
Press DISPLAY MODE.
Each time you press DISPLAY MODE, the display
changes as follows:
Full Display/Full Brightness t Full Display/Dimmed
t Minimal Display/Full Brightness t Minimal
Display/Dimmed
The setting remains in effect until you change it again.
If you press one of the buttons on this unit, the
1)
minimal display changes to the full display with the
selected brightness. After about 4 seconds, the display
returns to the display mode you selected.
Advanced Tuner Operations
Preset number/Frequency
(Normal display)
r
2)
PTY
r
2)
Radio Text
r
Clock time 2)
r
Signal Level
GB
17