Computer Operation; Nfc Function; Bluetooth Function - Sony RSX-GS9 Bedienungsanleitung

Computer operation

No sound or the sound is not output properly.
 The unit does not recognize the computer as a
USB device.
 Restart your computer.
 Install the driver software "Sony USB Device
Driver" on your Windows computer if not
installed. For details on the driver software,
visit the support site on the back cover.
For the installation, refer to the help guide of
your computer.
 Turn up the volume of your computer or
software.
 The computer is connected to the unit while
audio playback software is in use.
 Restart the audio playback software on the
computer.
 Check that the audio playback software being
used is compatible with the High-Resolution
Audio files. Using "Hi-Res Audio Player" or
"Media Go" is recommended. For details, visit the
support site on the back cover.
 The computer enters standby, sleep or
hibernation mode during playback.
 Restart the audio playback software on the
computer.
 Check that the sound device settings of your
computer are properly made.
For details, refer to the manual supplied with
your computer.
 Cancel the sound attenuation of your computer
or the audio playback software.
 Check that the CD-ROM drive supporting the
digital reproduction function is used.

NFC function

One touch connection (NFC) is not possible.
 The BLUETOOTH signal of this unit is not turned
on.
 Press and hold MENU on the remote
commander, select [BT Setting]  [BT Signal],
then press ENTER.
 If the smartphone does not respond to the
touching.
 Check that the NFC function of the smartphone
is turned on.
 Move the N-Mark part of the smartphone
closer to the N-Mark part on this unit.
 If the smartphone is in a case, remove it.
 NFC receiving sensitivity depends on the device.
If One touch connection with the smartphone
fails several times, make BLUETOOTH connection
manually.
26
GB

BLUETOOTH function

The connecting device cannot detect this unit.
 Before the pairing is made, set this unit to pairing
standby mode.
 While connected to a BLUETOOTH device, this
unit cannot be detected from another device.
 Disconnect the current connection and search
for this unit from another device.
 When the device pairing is made, set the
BLUETOOTH signal output to on (page 10).
Connection is not possible.
 The connection is controlled from one side (this
unit or BLUETOOTH device), but not both.
 Connect to this unit from a BLUETOOTH device
or vice versa.
The name of the detected device does not
appear.
 Depending on the status of the other device, it
may not be possible to obtain the name.
No ringtone.
 Adjust the volume by rotating the volume dial
while receiving a call.
 Depending on the connecting device, the
ringtone may not be sent properly.
 Set [Ring Tone] to [TONE 1] (page 18).
 The ringtone is output only from an audio device
connected to FRONT AUDIO OUT.
 Connect an audio device to FRONT AUDIO OUT
of the unit.
The talker's voice cannot be heard.
 The talker's voice is output only from an audio
device connected to FRONT AUDIO OUT.
 Connect an audio device to FRONT AUDIO OUT
of the unit.
A call partner says that the volume is too low or
high.
 Adjust the volume accordingly using mic gain
adjustment (page 15).
Echo or noise occurs in phone call conversations.
 Lower the volume.
 Set EC/NC Mode to [ECNC 1] or [ECNC 2] (page 15).
 If the ambient noise other than the phone call
sound is loud, try reducing this noise.
E.g.: If a window is open and road noise, etc., is
loud, shut the window. If an air conditioner is
loud, lower the air conditioner.
The phone sound quality is poor.
 Phone sound quality depends on reception
conditions of cellular phone.
 Move your car to a place where you can
enhance the cellular phone's signal if the
reception is poor.