Replacing The Lamp - Sony VPL-MX25 Bedienungsanleitung

Replacing the Lamp

The lamp used as a light source is a
consumable product. Thus, replace the
lamp with a new one in the following
cases.
• When the lamp has burnt out or dims
• "Please replace the Lamp." appears on the
screen
• The LAMP/COVER indicator flashes in
orange (Repetition rate of 3 flashes) (Refer
to page 14 for another possible cause.)
The lamp life varies depending on
conditions of use.
Use an LMP-M200 Projector Lamp as the
replacement lamp.
Use of any other lamps than the LMP-
M200 may cause damage to the projector.
Caution
The lamp remains not after the projector is turned
?/1
off with the key. If you touch the lamp, you
may burn your finger. When you replace the
lamp, wait for at least an hour for the lamp to
cool.
Notes
• If the lamp breaks, contact qualified Sony
personnel.
• Pull out the lamp by holding the handle. If
you touch the lamp, you may be burned or
injured.
• When removing the lamp, make sure it
remains horizontal, then pull straight up. Do
not tilt the lamp. If you pull out the lamp
while it is tilted and if the lamp breaks, the
pieces may scatter, causing injury.
1
Turn off the projector, and disconnect the
AC power cord from the AC outlet.
Note
When replacing the lamp after using the
projector, wait for at least an hour for the
lamp to cool.
2
Place a protective sheet (cloth) beneath the
projector. Turn the projector over so you
can see its underside.
Note
Be sure that the projector is stable after
turning it over.
10
GB
Replacing the Lamp
3
Open the lamp cover by loosening the two
screws with a Phillips screwdriver.
Note
For safety reasons, do not loosen any other
screws.
4
Loosen the two screws on the lamp unit
with the Phillips screwdriver (a). Fold out
the handle (b), then pull out the lamp unit
by the handle (c).
Fold out the handle.
Caution
Do not put your hands into the lamp
replacement slot, and do not allow any liquid
or other objects into the slot to avoid
electrical shock or fire.
Bottom