Werbung
Verfügbare Sprachen
Verfügbare Sprachen
-
Observe the minimum clearances to combustible surfaces indicated in this manual. These
must be in accordance with the information on the nameplate and with local regulations
and standards.
-
If the hob is installed near a window, appropriate precautions must be taken to prevent
curtains from flying over the burners, as this would pose a serious fire hazard.
-
When choosing the location of the hob, consider the position of the gas and electricity
supply pipes.
-
The gas supply and electrical power must be closed at the time of installation.
-
Do not install another hob next to this appliance.
-
Check the underside of the worktop to ensure that there are no protrusions. Make sure the
worktop is solid, can support the weight of the hob and is level.
-
Make sure that the location where you place the hob is well ventilated. Make sure that the
ventilation is not obstructed by bulky objects, etc.
-
Remember to glue the sealing gasket on the hob panel before installing it on the worktop.
-
RISK OF CUTS. Please note that the edges of the stainless-steel hobs can cause cuts,
extreme caution must be taken when handling.
-
Figure 2 shows the safety distances to be observed when installing the hob.
Installation of the hob under a piece of furniture
-
Always make sure the hob is well ventilated and that the air inlet and outlet are not
blocked. Make sure the hob works properly.
-
The following table shows the installation dimensions corresponding to figure 3:
A
B
700 mm
min 100 mm
Note: the safety distance between the hob and a cabinet over the hob must be at least 700 mm.
Warning: in case of breakage of the hob glass (depending on the model):
immediately switch off all burners and any electrical heating elements and
disconnect the appliance from the mains. Do not touch the surface of the
appliance. Stop using the hob.
Installation on a worktop
The following table shows the appliance dimensions and the cutting dimensions of the
worktop, corresponding to figure 4.
C
D
min 20 mm
Air inlet
BOLERO SQUAD G 1200F / 2200F / 3200F / 4200F / 5200F GLASS BLACK
E
Air outlet 5 mm
ENGLISH
81
Werbung
