cecotec BOLERO COOLMARKET TF 85 WHITE E Bedienungsanleitung Seite 55

Fig. 7 key:
1. Freezer-compartment door
2. Stop
Fig. 8 key:
1. Stop
2. Hole cover
Fig. 9 key:
1. Top cover
2. Screws
3. Top hinge
4. Screw hole cover
1
Make sure the appliance is unplugged.
2
Remove the screw hole covers and top cover screws. Then, remove the cover. Next,
remove the three screws from the top hinge to remove it. Fig. 3
3
Remove the door.
4
Remove the screws securing the bottom hinge on the right side of the appliance, then
remove the hinge. Fig. 4
5
Remove the washer and nut securing the pin shaft from the right side hole in the bottom
hinge, then remove the shaft. Fig. 5
6
Introduce the shaft pin in the lower hinge left hole and fix the shaft with the washer and
the nut. Fig. 6.
7
Install the bottom hinge on the left side of the appliance.
8
Remove the screw that holds the door stop on the bottom right side of the door, then
remove the door stop from the door. After that, install them in the bottom left side. Fig. 7
9
Place the door.
10
Move the door bushing from the top right side to the top left side. Next, move the left hole
cover to the right side. Fig. 8
11
Attach the top hinge to the top left side of the appliance with the screws removed before.
Before tightening the top hinge screws, make sure that the top of the door is level with the
appliance and that the rubber gasket makes a good seal. Fig. 9
12
Fit the top cover.
Note: when installing the door, make sure that the top of the door is flush with the top of the
appliance. If the door is not level, the rubber gasket will not seal properly, which may cause the
appliance to malfunction.
Bolero CoolMarket TF 85 White E
Bolero CoolMarket TF 85 Inox E
Bolero CoolMarket TF 85 Black E
ENGLISH
55